The Chromozone / Courses / IGCSE Co-ordinated Sciences / Chemistry / C1 States of matter

Cambridge IGCSE Co-ordinated Sciences (0654) · Chemistry · C1 States of matter · Homework: extend

Heating and squeezing a gas, and melting a pure solid

Syllabus C1.1Homework: extendAbout 22 minutes16 marks (Core 12)
Back to the lesson

Homework: extend. It builds on the lessons "Melting and boiling points: the practical" and "Gas pressure and the volume of a gas": you use what you learned in a new situation. It takes about 22 minutes and is worth 16 marks. Questions marked "Extended only" are for Extended students. Core students skip them and are marked out of 12. Type your answers in the boxes, then hand them in at the bottom of the page. The mark schemes open after you hand in. Then mark your work point by point and correct it in a different colour. The brackets after each question give the syllabus section.

Teach these first

This homework builds on these lessons. Teach them before students start here:

Questions 1 and 2: heating a gas (6 marks) 9 min

A student traps some air in a gas syringe, seals the end and stands the syringe in a water bath. The plunger moves freely, so the pressure of the air stays the same. She measures the volume of the air at four temperatures. Table 1.1 shows her results.

Table 1.1
Temperature of the air / °C20406080
Volume of the air / cm³50.053.456.860.2

1(a). Describe the effect of temperature on the volume of the air. Use data from Table 1.1. (C1.1, Gas pressure and the volume of a gas) (2)

1(b). Estimate the volume of the air at 100 °C. (C1.1, Gas pressure and the volume of a gas) (1)

Volume (cm³)

A table-tennis ball has a dent in it. The ball is sealed, so no air can get in or out. When the ball is put into hot water, the dent pops out.

2(a). State what happens to the volume of the air inside the ball as it warms up. (C1.1, Gas pressure and the volume of a gas) (1)

2(b). Extended only Explain, using kinetic particle theory, why the air pushes the dent out. (C1.1, Gas pressure and the volume of a gas) (2)

Mark scheme: questions 1 and 2

1(a) (2)

  • As the temperature increases, the volume of the air increases (1)
  • Data quoted with units, e.g. the volume goes up by 3.4 cm³ for every 20 °C, or from 50.0 cm³ at 20 °C to 60.2 cm³ at 80 °C (1)
  • The data must be quoted correctly, with units (°C and cm³), for the second mark. "It gets bigger" with no data: 1 mark.

1(b) (1)

  • 63.6 cm³ (1)
  • Working: the volume rises by 3.4 cm³ for every 20 °C, so 60.2 + 3.4 = 63.6. Accept any value from 63 to 64 cm³. 60.2 (no change) or 70: 0 marks.

2(a) (1)

  • It increases (the air expands) (1)
  • "The air gets lighter" or "the pressure goes down": 0 marks.

2(b) (2)

  • The air particles gain kinetic energy and move faster (1)
  • So they hit the inside wall of the ball more often and harder: the pressure of the air increases and pushes the dent outwards (1)
  • 0 marks for "the particles expand" or "the particles get bigger": particles do not change size. Teacher note: the hot water also softens the plastic, which helps the dent pop out.

Question 3: melting a pure solid (8 marks) 9 min

Substance Z is a white solid. A student puts some powdered Z in a boiling tube with a thermometer, and stands the tube in a beaker of hot water (a water bath). She stirs Z gently and reads the temperature every minute. Table 3.1 shows her results. The Z was a solid at the start and a liquid at the end.

Table 3.1
Time / minutes012345678910
Temperature of Z / °C2532384344444444475359

3(a). Use Table 3.1 to give the melting point of Z. (C1.1, Melting and boiling points: the practical) (1)

Melting point (°C)

3(b). Describe what happens to the temperature from 4 minutes to 7 minutes, and state what is happening to Z during this time. (C1.1, Melting and boiling points: the practical) (2)

3(c). Extended only The student lets the liquid Z cool down. Predict the temperature at which it turns back into a solid, and explain, using kinetic particle theory, what happens to the particles as the liquid turns into a solid. (C1.1, Melting and boiling points: the practical) (2)

3(d). She repeats the experiment with a sample of Z that contains an impurity. Suggest two ways in which her results would be different. (C1.1, Melting and boiling points: theory) (2)

3(e). Suggest why she heated Z in a water bath instead of heating the tube directly in a Bunsen burner flame. (C1.1, Melting and boiling points: the practical) (1)

Mark scheme: question 3

3(a) (1)

  • 44 °C (1)
  • The temperature that stays the same while Z melts. 25 °C or 59 °C: 0 marks.

3(b) (2)

  • The temperature stays the same (constant), at 44 °C (1)
  • Z is melting: changing from a solid to a liquid (1)
  • "The temperature stops" or "nothing happens": 0 for the first mark. Do not accept "boiling" or "dissolving" for the second mark.

3(c) (2)

  • It turns back into a solid at 44 °C (the freezing point is the same as the melting point) (1)
  • The particles lose (kinetic) energy and slow down; the forces of attraction hold them in a regular arrangement, where they vibrate about fixed positions (1)
  • 0 for the second mark: "the particles stop moving" (they still vibrate), or "the particles get smaller".

3(d) (2)

  • Z would melt at a lower temperature (below 44 °C) (1)
  • It would melt over a range of temperatures: the flat part of the results would slope (the temperature would not stay exactly the same) (1)
  • "It melts at a higher temperature": 0 marks (an impurity lowers the melting point). "The results would be wrong" with no detail: 0 marks.

3(e) (1)

  • A water bath heats Z gently and evenly, so the temperature rises slowly and steadily and she can read it every minute (1)
  • Accept "so it does not heat too fast" or "so there are no hot spots". "To be safe" on its own: 0 marks (the question asks about the results).

Question 4: squeezing a gas (2 marks) 3 min

A student blocks the end of a bicycle pump and pushes the handle in slowly, so that the temperature of the trapped air stays the same. A gauge on the pump shows the pressure of the air. Table 4.1 shows her results.

Table 4.1
Pressure of the air / kPa100160200400
Volume of the air / cm³80504020

4. Describe how the volume of the air changes as its pressure increases. Use data from Table 4.1. (C1.1, Gas pressure and the volume of a gas) (2)

Mark scheme: question 4

4 (2)

  • As the pressure increases, the volume of the air decreases (1)
  • Data quoted with units, e.g. when the pressure doubles from 100 kPa to 200 kPa, the volume halves from 80 cm³ to 40 cm³ (1)
  • Any correct pair of readings with units scores the second mark. "The volume goes up": 0 marks.

Back to the lesson

Was this page useful?

Goes straight to the two people who make these pages. Please don't include students' names or other personal details.