The Chromozone / Courses / IGCSE Co-ordinated Sciences / Physics / P1.1 Physical quantities and measurement techniques

Cambridge IGCSE Co-ordinated Sciences (0654) · Physics · P1.1 Physical quantities and measurement techniques · Homework: extend

Measuring a thin wire, a potato, a swing and a toy car

Syllabus P1.1Homework: extendAbout 18 minutes13 marks
Back to the lesson

Homework: extend. It builds on the lessons "Measuring length and volume" and "Measuring time": you use what you learned in a new situation. It takes about 18 minutes and is worth 13 marks. Every question is for Core and Extended students. Type your answers in the boxes, then hand them in at the bottom of the page. The mark schemes open after you hand in. Then mark your work point by point and correct it in a different colour. The brackets after each question give the syllabus section.

Teach these first

This homework builds on these lessons. Teach them before students start here:

Question 1: a very thin wire (4 marks) 5 min

A student wants to find the diameter of a thin copper wire. She winds the wire tightly around a pencil 25 times, with each turn touching the next. She then measures the length of the coil with a 30 cm ruler. The coil is 2.0 cm long.

1(a). Calculate the diameter of the wire, in mm. (P1.1, Measuring length and volume) (2)

Working
Diameter (mm)

1(b). Explain why she measures the length of 25 turns instead of measuring one turn. (P1.1, Measuring length and volume) (2)

Mark scheme: question 1

1(a) (2)

  • 2.0 cm = 20 mm, and 20 ÷ 25 (or 2.0 ÷ 25 = 0.080 cm) (1)
  • = 0.80 mm (1)
  • Correct answer with no working: 2 marks. Accept 0.8 mm. 0.08 written as the answer in mm (not changed from cm): 1 mark. 50 (25 × 2.0) or 12.5 (25 ÷ 2.0): 0 marks.

1(b) (2)

  • One turn (about 0.8 mm) is smaller than the smallest division on the ruler (1 mm), so it cannot be measured accurately on its own (1)
  • The reading error is about the same for 25 turns as for one, so dividing by 25 shares it out and makes the answer more accurate (1)
  • It gives an average (mean) value for one turn (1)
  • Max 2. "To be fair" or "to make it reliable" with no reason: 0 marks.

Question 2: the volume of a potato (2 marks) 3 min

A potato is too big to fit into a measuring cylinder. A student finds its volume with a displacement can (overflow can) and a measuring cylinder. The potato sinks in water.

2(a). He fills the can with water up to its spout, then lowers the potato into the can and collects the water that overflows. The measuring cylinder now contains 140 cm³ of water. State the volume of the potato. (P1.1, Measuring length and volume) (1)

Volume (cm³)

2(b). Explain why the can must be filled with water up to its spout before the potato is lowered in. (P1.1, Measuring length and volume) (1)

Mark scheme: question 2

2(a) (1)

  • 140 cm³ (1)
  • The unit is on the answer line, so accept 140.

2(b) (1)

  • So that all the water the potato pushes aside (displaces) overflows into the measuring cylinder; otherwise the level first rises to the spout and less water is collected than the volume of the potato (1)
  • Accept any clear statement that the volume collected would otherwise be too small. "So it does not spill" or "to make it accurate" with no reason: 0 marks.

Question 3: the period of a swing (3 marks) 4 min

A student finds the period of a swing in a playground. She pulls the empty swing back, lets it go, and times 10 complete oscillations with a stopwatch. She does this four times. Table 3.1 shows her results.

Table 3.1
Trial1234
Time for 10 oscillations / s28.628.231.128.4

3(a). Identify the anomalous result. (P1.1, Measuring time) (1)

3(b). Calculate the period of the swing. Do not use the anomalous result. (P1.1, Measuring time) (2)

Working
Period (s)
Mark scheme: question 3

3(a) (1)

  • 31.1 s (trial 3) (1)
  • Teacher note: it is about one period too long, so she probably counted 11 oscillations.

3(b) (2)

  • Mean time for 10 oscillations = (28.6 + 28.2 + 28.4) ÷ 3 = 28.4 s (1)
  • Period = 28.4 ÷ 10 = 2.84 s (1)
  • Accept 2.8 s. Correct answer with no working: 2 marks. If the anomalous result is included (mean 29.1 s, period 2.91 s): 1 mark. 28.4 s given as the period (not divided by 10): 1 mark.

Question 4: timing things (4 marks) 5 min

Timers come in different kinds: a clock, a stopwatch, and light gates connected to a digital timer.

4(a). Choose the best timer for each of these: (i) the time for a candle to burn down, about 2 hours; (ii) the time for 30 heartbeats, about 25 seconds; (iii) the time for a toy car to pass between two marks 20 cm apart, about 0.3 seconds. (P1.1, Measuring time) (2)

(i)
(ii)
(iii)

4(b). A stopwatch shows 03:05.60 (minutes : seconds). Write this time in seconds. (P1.1, Measuring time) (1)

Time (s)

4(c). Three students use stopwatches to time the same toy car between the same two marks. They get 0.6 s, 1.1 s and 0.9 s. Light gates give 0.31 s. Suggest why the three stopwatch times are so different from each other and from the light-gate time. (P1.1, Measuring time) (1)

Mark scheme: question 4

4(a) (2)

  • (i) a clock (or a watch); (ii) a stopwatch; (iii) light gates with a digital timer (2)
  • All three correct: 2 marks. Two correct: 1 mark. (iii) "stopwatch": wrong, because 0.3 s is too short to time by hand.

4(b) (1)

  • 185.6 s (1)
  • Working: 3 minutes = 180 s, and 180 + 5.60 = 185.6 s. Accept 185.60 s. 305.6 or 3.056: 0 marks.

4(c) (1)

  • Each person has a reaction time when starting and stopping the stopwatch, and it is different for each person (and each time); the light gates start and stop automatically (1)
  • "Human error" on its own: 0 marks; the answer needs the idea of reaction time (a delay in starting or stopping).

Back to the lesson

Was this page useful?

Goes straight to the two people who make these pages. Please don't include students' names or other personal details.