The Chromozone / Courses / IGCSE Co-ordinated Sciences / Tests

Part A is multiple choice; Part B is short and long answers, written on the printed paper or in books. The mark scheme is in the teacher area. Questions A5, A7, A8, A9 and the parts of B2 and B3 and B5 tagged "Extended only" are for Extended students only: Core students leave them out and are marked out of 23. Students can also answer online: Part A marks itself, and you mark Part B.

Cambridge IGCSE Co-ordinated Sciences (0654) · Physics · Section P1.5

End-of-section test: forces

About 40 minutesExtended: 40 marksCore: 23 marks, about 25 minutesCalculator allowed
Name
Date
Score/ 40 (Core / 23)
Instructions
  • Answer all the questions. If you are a Core student, leave out the questions marked Extended only.
  • Part A: choose one answer, A, B, C or D, for each question. On screen, click it. On paper, put a cross in its box; if you change your mind, draw a line through the cross and cross another box.
  • Part B: write your answers in the spaces. Show your working in calculations.
  • The marks for each question are shown in brackets.
  • Handing in online: choose your Part A answers, type each Part B answer in the box under the question, then press Hand in at the end.

Part A: multiple choice (10 marks, marks itself online)

A1

Which object has no resultant force acting on it?

(1)
A2

A motorbike pulls away from a set of traffic lights and its speed increases rapidly. A forward force from the engine and a backward force from friction and air resistance act on it. Which row best describes the two forces?

forward forcebackward force
2400 N300 N
900 N850 N
600 N600 N
300 N2400 N
(1)
A3

Each of four blocks has two vertical forces acting on it, along the same line. Which block is in equilibrium?

upward forcedownward force
6.0 N4.0 N
2.5 N5.0 N
4.5 N4.5 N
8.0 N0.8 N
(1)
A4

Which statement is correct for an object that has no resultant force acting on it?

(1)
A5

Extended onlyA car of mass 1200 kg is moving at 18 m/s. The driver brakes, and the car slows down steadily and stops in 6.0 s. What is the size of the resultant force on the car while it slows down?

(1)
A6

Three beams, P, Q and R, are each pivoted at their centre. Two weights hang from each beam, one on each side of the pivot, as shown in the table.

Table A6.1

beamweight on the leftdistance from the pivotweight on the rightdistance from the pivot
P5.0 N0.40 m3.0 N0.80 m
Q6.0 N0.50 m4.0 N0.60 m
R2.0 N0.90 m9.0 N0.20 m

Which beams turn clockwise (the right-hand side goes down) when they are let go?

(1)
A7

Extended onlyA rod is balanced on a pivot at its centre. A 4.0 N load hangs 15 cm to the left of the pivot. Identical 0.50 N weights are hung together from one point, 10 cm to the right of the pivot. How many 0.50 N weights are needed to balance the rod?

(1)
A8

Extended onlyA lorry of mass 5000 kg drives along a flat road. The driving force from its engine is 9500 N, and a backward drag force also acts on it. The lorry accelerates at 1.2 m/s². What is the drag force?

(1)
A9

Extended onlyFour objects are each acted on by two horizontal forces, as shown. Which object has the largest acceleration?

massforce to the rightforce to the left
0.50 kg5.0 N3.0 N
2.0 kg20 N6.0 N
4.0 kg30 N10 N
10 kg60 N10 N
(1)
A10

Fig. A10.1 shows how the speed of a cyclist changes during a journey. In which section of the journey is the resultant force on the cyclist zero?

Speed-time graph of a cyclistSpeed in metres per second against time in seconds. Section W: the speed rises steadily from 0 to 8 metres per second in the first 10 seconds. Section X: the speed stays at 8 metres per second from 10 to 25 seconds. Section Y: the speed rises to 12 metres per second at 30 seconds. Section Z: the speed falls steadily to 0 at 45 seconds.05101520253035404502468101214time / sspeed / m/sWXYZ
Fig. A10.1: a cyclist's journey along a straight, flat roadDiagram: The Chromozone, simplified
(1)

Total for Part A: 10 marks (Core: 6 marks)

Part B: short and long answers (30 marks, marked by your teacher)

Question B1

Fig. B1.1 shows the two vertical forces on a hot-air balloon and its basket just after it leaves the ground.

Forces on a hot-air balloonA box labelled balloon and basket. An arrow labelled 8200 newtons points up from its top. An arrow labelled 7900 newtons, weight, points down from its bottom.balloon8200 N upward force7900 N weight
Fig. B1.1: the vertical forces on a hot-air balloon just after it leaves the groundDiagram: The Chromozone, simplified
(a)

Calculate the resultant force on the balloon and state its direction.

resultant force
direction
(2)
(b)

Describe the effect of this resultant force on the motion of the balloon.

(1)
(c)

Later, the balloon rises at a steady speed. Its weight is still 7900 N. State the size of the upward force from the hot air now, and give a reason.

upward force
reason
(1)

(Total for Question B1 = 4 marks)

Question B2 Extended only

Extended onlyA student hangs loads on two different springs, P and Q, and measures the extension of each. Fig. B2.1 shows her results.

Load-extension graphs for springs P and QExtension in centimetres against load in newtons for two springs. Spring P is a straight line through the origin, reaching 12 centimetres at 6 newtons. Spring Q is a steeper straight line through the origin up to 12 centimetres at 3 newtons; after that it curves upwards, reaching about 22 centimetres at 4.3 newtons.012345604812162024load / Nextension / cmspring Pspring Q
Fig. B2.1: load-extension graphs for two springs, P and QDiagram: The Chromozone, simplified
(a)

Extended onlyUse Fig. B2.1 to find the extension of spring P when the load is 3.0 N.

extension =cm

(1)
(b)

Extended onlyState which spring is easier to stretch. Give a reason, using Fig. B2.1.

spring
reason
(2)
(c)

Extended onlyCalculate the spring constant of spring P. Show your working and give the unit.

spring constant =

(2)
(d)

Extended onlyThe graph for spring Q stops being a straight line. State the name of the point where this happens.

(1)
(e)

Extended onlyDescribe one thing the student should do so that her length readings are accurate.

(1)

(Total for Question B2 = 7 marks)

Question B3 Extended only

Extended onlyA crane lifts a steel beam of mass 600 kg straight upwards. The beam hangs from the crane's cable. As the lift starts, the beam accelerates upwards at 0.50 m/s². Use g = 9.8 N/kg.

(a)

Extended onlyCalculate the weight of the beam.

weight =N

(1)
(b)

Extended onlyCalculate the resultant force needed to give the beam this acceleration.

resultant force =N

(1)
(c)

Extended onlyCalculate the upward force that the cable must exert on the beam.

upward force =N

(1)
(d)

Extended onlyState the direction of the beam's acceleration compared with the direction of the resultant force.

(1)

(Total for Question B3 = 4 marks)

Question B4

In the sport of curling, a heavy granite stone slides across a sheet of ice. Players sweep the ice in front of the moving stone with brushes. Sweeping warms the ice slightly and makes it smoother.

(a)

Explain how sweeping helps the stone to travel further.

(2)
(b)

The brushes rub hard on the ice. Apart from opposing motion, state one effect of the friction between a brush and the ice.

(1)
(c)

Air resistance also acts on the moving stone. State how the air resistance changes as the stone slows down.

(1)

(Total for Question B4 = 4 marks)

Question B5

Fig. B5.1 shows a uniform plank of weight 150 N, balanced on a pivot at its centre. A 300 N box sits on the plank 0.80 m to the left of the pivot, and a 200 N bag of cement sits a distance d to the right of the pivot.

A plank balanced on a pivotA uniform plank 4.0 metres long rests on a pivot at its centre. A 300 newton box sits 0.80 metres to the left of the pivot. A 200 newton bag sits a distance d to the right of the pivot. An arrow labelled R shows the pivot pushing up on the plank.pivotR300 N box200 N bag0.80 md
Fig. B5.1: a uniform plank, balanced on a pivot at its centre (not to scale for d)Diagram: The Chromozone, simplified
(a)

Calculate the moment of the box about the pivot. Give the unit.

moment =

(2)
(b)

Extended onlyThe plank is balanced. Use the principle of moments to calculate the distance d.

d =m

(2)
(c)

The plank is in equilibrium. Calculate the upward force R of the pivot on the plank.

R =N

(1)

(Total for Question B5 = 5 marks)

Question B6

This question is about the centre of gravity.

(a)

State what is meant by the centre of gravity of an object.

(1)
(b)

A student has a thin, flat piece of card with an irregular shape. Describe how she can find its centre of gravity, using a pin in a clamp and a plumb line.

(3)
(c)

A desk lamp has a heavy, wide base. Explain why the heavy base makes the lamp more stable.

(2)

(Total for Question B6 = 6 marks)

Total for Part B: 30 marks (Core: 17 marks)

TOTAL FOR TEST = 40 MARKS (CORE: 23 MARKS)

Was this page useful?

Goes straight to the two people who make these pages. Please don't include students' names or other personal details.